If your lamp goes out suddenly, you might hear a popping noise, after which the screen goes dark. Your television will boot up in service mode. Disconnect the power cord from the outlet, then press and hold the power button on the TV not the remote , for at least 10 seconds.
What was it replaced with? These are both ventalated lamps which seem to run cooler and hence, are more reliable. Ok, well Two things you need to consider. As long as you do not have the oddball enclosure type ah Second thing to consider: as long as your original enclosure is NOT the following, you are ok! A brief explaination of each is below:. This was a W lamp, matched with a W ballast. Much of this has been documented on other pages on this site, please take a look for a more complete history.
All in all, if you're confused, it's not your fault -- it's Samsung's! Remove the screws and the color wheel. To remove the wheel cleanly, I lifted the front edge and slid it toward the front.
Insert the new colorwheel. It can be tricky to do this without touching the wheel, or bumping the wheel into the case. This is where you need the nerves of steel.
Once you get the proper angle, it will slide into place. At first, I tried to put it in place with the screws already in the holes. Lesson learned: put it in without the screws and then hold the screws in place with tweezers, if necessary.
Put the color wheel cover back on with the wires out the space facing the front of the case. Make sure the wires reach their destinations, and screw in the cover.
Three screws. Attach the three connectors. The metal contacts on the ribbon cable face the rear. Put all the guts back in place. Slide the center unit back in. Without touching the projector lens, open up the slice in the foam so it wraps around the projector lens, and slide it in the rest of the way. Connect the two wires you removed on the left side. They should only go in one way.
Screw the sensor switch onto the bracket on the right. Just the way you noted on the way out. Slide the left PC board and panel back in place. There are two screws that hold it in place that you screw in now, the rest hold on the access panel. Put the projector lamp back in place and screw it into place. I forgot to do this both times. Put the access panel back on and screw it in 14 screws Plug in the television, say a prayer, and turn it on.
Comments I realize this post is almost 14 years old, but I just wanted to say that it was very helpful to me in fixing up my old TV just this week.
Leave a Reply Cancel reply Your email address will not be published. Footer Contact email. Follow us facebook twitter instagram. Installation is fast and simple, leaving you more time to relax and watch your favorite movies or shows. BPA Need a new lamp for your Samsung television? For selecting the right replacement lamp for your specific TV, just remove the lamp from your TV and identify the lamp code on the lamp, or contact us for help.
This high-quality lamp is guaranteed to fit the Samsung televisions featured on this page.
0コメント